Mendoza
CONTROLS
(904) 862-3575
SERVICES / PRESSES

Power Press Repair & Safety Controls

Press controls, light curtains, and clutch and brake valve repair for mechanical presses. Safety circuits get the same attention as the drive, because the press does not run correctly without both.

Gap-frame mechanical punch press with a clear point-of-operation guard over the die area and sheet stock running across the outboard support table

WHAT WE DO

The first question on any press call is whether the press has stopped cycling for a mechanical reason or because a safety circuit has tripped and will not reset. That answer sets the scope, the cost, and whether the work touches the safety system at all.

Punch press repair and stamping press repair are handled alongside press safety controls: two hand control press wiring, light curtain installation and alignment, and dual safety valve monitoring on the clutch and brake. Clutch brake control repair addresses valve faults that present as slow or incomplete strokes. On older mechanical press repair calls where the controls no longer meet current OSHA press safety requirements, press control retrofit replaces only what inspection requires instead of rebuilding the press. Safety-related work is function tested with your people present and documented, so the press returns to production with a record of what was verified.

BRANDS & PLATFORMS

Allen-Bradley Banner SICK Rockford Systems Wintriss ProCam

FREQUENTLY ASKED QUESTIONS

What's the difference between punch press repair and press safety controls work? Punch press repair and stamping press repair cover the mechanical and drive side, meaning clutch, brake, and cycle faults. Press safety controls covers light curtains, two hand control wiring, and the safety relays that must pass inspection on their own.
Do you install light curtains? Yes. Light curtain installation and alignment is part of most press safety controls jobs, along with dual safety valve monitoring on the clutch and brake, and the installation is function tested and documented before the press returns to production.
Can you bring an older press up to current OSHA requirements? Press control retrofit work exists for this purpose: meeting OSHA press safety requirements without rebuilding the press. We scope only what inspection requires and give you the cost before work starts.
What causes a press to stop mid-stroke? Most often a clutch brake control repair issue, such as a valve that is not fully shifting, or a safety circuit fault from a light curtain or two hand control press that is not resetting cleanly. The distinction is confirmed before parts are ordered.
Is there punch press repair near me? We dispatch out of Jacksonville with same-day response across the surrounding area, and scheduled visits statewide.

RELATED SERVICES

ALL SERVICES →