Mendoza
CONTROLS
(904) 862-3575
SERVICES / PRESSES

Hot Press Repair & Controls

Heating zones, thermocouples, and cycle control for hot and laminating presses. Uneven platen temperature is usually a controls problem rather than a heater problem, and it is verified zone by zone.

Hot press with the platens open, showing the heated upper platen, guide posts and lower die block

WHAT WE DO

An uneven platen almost always traces back to one failed thermocouple or heater element rather than the whole system, so hot press temperature control is verified zone by zone before anything is replaced.

Platen press repair and laminating press repair come down to the same checks: heating zones, thermocouples, and the cycle timer that ties them together. Industrial heat press repair often involves a controller that has drifted out of calibration rather than failed, and recalibration is quoted before replacement is considered. Hot press machine repair also covers the hydraulic side, where pressure that will not hold through a full cycle points to a valve or seal issue separate from the heat. Zone readings are documented before and after the work, so you can see the platen back inside tolerance.

BRANDS & PLATFORMS

Watlow Eurotherm Allen-Bradley Siemens

FREQUENTLY ASKED QUESTIONS

Why is my platen heating unevenly? Usually one failed thermocouple or heater element in a single zone rather than a system-wide failure. Hot press temperature control diagnosis checks each zone independently before anything is replaced, and readings are documented before and after.
Do you work on laminating presses too? Yes. Laminating press repair follows the same heating zone and cycle timer checks as platen press repair.
What if the press won't hold pressure through a cycle? That points to a hydraulic valve or seal issue separate from the heating system. Hot press machine repair covers both sides of the press, so a heat call does not turn into a second visit for hydraulics.

RELATED SERVICES

ALL SERVICES →