Mendoza
CONTROLS
(904) 862-3575
SERVICES / PLASTICS

Extruder Repair & Controls

Zone temperature control, gearbox repair, and line speed sync for plastic extrusion machines. We work the controls and the mechanical drivetrain together, so a fault is not handed back and forth between trades.

Extruder line with feed hopper, gearbox and drive motor alongside its control cabinet on a plant floor

WHAT WE DO

Extrusion faults get diagnosed zone by zone rather than by replacing parts in sequence. Tell us where the output changed and what the temperature controller is reading, and the scope is usually clear before a truck is on the road.

Extruder temperature controller and extruder barrel heater faults are checked zone by zone so only the failed element is replaced. Extruder gearbox repair addresses bearing wear, gear noise, and overheating while a repair is still less expensive than a rebuild, and extruder screw repair addresses wear that shows up as inconsistent output long before the screw fails outright. Plastic extrusion machine repair calls that arrive as a line running out of sync start with the drive and encoder feedback before the controls are touched. You receive the findings, the cost, and what is worth watching between now and your next scheduled shutdown.

BRANDS & PLATFORMS

Allen-Bradley Siemens Eurotherm Watlow Davis-Standard Bausano

FREQUENTLY ASKED QUESTIONS

What's covered under extruder controls repair? Extruder temperature controller faults, extruder barrel heater failures, and the drive and encoder feedback that holds line speed in sync downstream. Each zone is verified against actual output before parts are quoted.
Do you do extruder gearbox repair or just electrical work? Both. Extruder gearbox repair covers bearing wear, gear noise, and overheating, and it is frequently tied to the same drive faults that present as speed sync problems, which is why the two are diagnosed on one visit.
What does extruder screw repair involve? Screw wear shows up as inconsistent output well before the screw fails outright, so flight wear and clearances are measured and reported as part of any plastic extrusion machine repair call. You get the measurements and a recommendation on how much run time is left.
Can you match a new controller to an old extruder? Yes. Where the existing controls are obsolete, a retrofit is quoted against the cost of chasing discontinued parts. See Machine Retrofit & Control Modernization for how that work is staged. View that page →

RELATED SERVICES

ALL SERVICES →